Seam taping of Wetsuit

Image Source-Google | Image by- | srface

To address these kind of early stitching troubles, taping of seams turned into advanced. The tape is a robust nylon material with a totally skinny however stable water resistant rubber backing. The tape is applied across the seam and bonded either with a chemical solvent or with a hot rolling warmth-sealer to melt the tape into the neoprene.

With this technology, the healthy may be sewn and then taped, and the tape might cowl the stitching holes as well as imparting some more strength to prevent tearing alongside the needle holes.

When colorful double-sponsored dressmaker suits commenced appearing, taping moved in most cases to the internal of the healthy because the tape became typically very wide, jagged, black, and unsightly, and changed into hidden within the fit and out of sight.

Many 1960s and 1970s wetsuits were black with seen yellow seam taping. The yellow made the divers more without problems visible in darkish low-visibility water. To avoid this problem O'Neill fabricators developed a seam-tape which mixed a skinny nylon layer with a polyester hemming tape. Applied over the interior of the glued & sewn seam, then anneal bonded with a handheld teflon heating iron produced a seam that turned into both securely sealed and much stronger.